SilverLexus
03-21-2006, 04:43 PM
Well this was a big 5 hour+ project. Here was my process:
1. Zaino Z-7 wash after EO All Wheel & Tire on the alloys (agitate for best results)
2. Claying X 2
3. Zaino Z-7 wash
4. Clayed wheels with ClayMagic
5. Z-6 wipedown
6. Polish with PC on "6" X 2 using Z-PC Fusion
7. Z-6 wipedown
8. Zaino Z-5
9. Zaino Z-8
10. Poorboys Trim Restorer
11. ArmorAll Detailers Advantage on all wheels including spare
After polishing the hood:
http://homepage.mac.com/leescoggins/disco1.jpg
Results:
http://homepage.mac.com/leescoggins/disco2.jpg
http://homepage.mac.com/leescoggins/disco3.jpg
http://homepage.mac.com/leescoggins/disco4.jpg
The Z-PC really brought out the flake this time. It was a bit dustier than other times I had used it but the dust particles seem to roll off easily after a trip around the block. This, like a lot of Zaino products, is one that seems to go a long way on a little bit. I use three small dots on a cutting pad. I got out 95% of the swirls and greatly minimized two deep scratches that I may take the rotary to later. This is my sister-in-law`s car.
We lost the sun so the pics are dark but I will post some sunny day photos tomorrow. :)
1. Zaino Z-7 wash after EO All Wheel & Tire on the alloys (agitate for best results)
2. Claying X 2
3. Zaino Z-7 wash
4. Clayed wheels with ClayMagic
5. Z-6 wipedown
6. Polish with PC on "6" X 2 using Z-PC Fusion
7. Z-6 wipedown
8. Zaino Z-5
9. Zaino Z-8
10. Poorboys Trim Restorer
11. ArmorAll Detailers Advantage on all wheels including spare
After polishing the hood:
http://homepage.mac.com/leescoggins/disco1.jpg
Results:
http://homepage.mac.com/leescoggins/disco2.jpg
http://homepage.mac.com/leescoggins/disco3.jpg
http://homepage.mac.com/leescoggins/disco4.jpg
The Z-PC really brought out the flake this time. It was a bit dustier than other times I had used it but the dust particles seem to roll off easily after a trip around the block. This, like a lot of Zaino products, is one that seems to go a long way on a little bit. I use three small dots on a cutting pad. I got out 95% of the swirls and greatly minimized two deep scratches that I may take the rotary to later. This is my sister-in-law`s car.
We lost the sun so the pics are dark but I will post some sunny day photos tomorrow. :)