View Full Version : Can VM remove haze?
I recently used a mixture of OP/OC (50/50) and I guess I didn`t let it break down properly and left some haze. My question is should I go at it again with OP or will VM clean it up?
Todd03Blown
03-16-2006, 08:15 AM
I recently used a mixture of OP/OC (50/50) and I guess I didn`t let it break down properly and left some haze. My question is should I go at it again with OP or will VM clean it up?
VM should be able to handle it as I have removed light wet sanding marks with it before but I am not an experience detailer and just detail my cars.
Thanks for the heads up, would you happen to know if mixing VM with RMG effect VM`s polishing ability?
White95Max
03-16-2006, 08:34 AM
VM and RMG are both light abrasive polishes with some cleaning ability. I don`t think VM would be affected at all by mixing in RMG, but I don`t see what benefit there would be either.
Accumulator
03-16-2006, 09:59 AM
I, on the other hand, never seem to get any abrasive effects from VM :nixweiss Give it a try, but be prepared to do something more aggressive.
Scottwax
03-16-2006, 10:08 AM
With a polishing pad and the PC on 5-6, you can remove light defects. Try VM first and if it isn`t strong enough, then step up to OP.
Joshua312
03-16-2006, 11:01 AM
This may sound out of the ordinary but I had some moderate micromarring and haze...tried a bunch of different things but amazingly what worked for me was
#80 Megs On a Finishing Pad
Speed at 5-6
Light to Moderate pressure
and it worked for me, I was working on my 99 Grand Prix Clear...good luck to you, let us know how it goes. I was going to try and get pictures as I only did 2 panels so far, but today it is snowing...so if my halogens dont show it I may have to wait.