View Full Version : Speed setting on a PC 7336
SmoothAsGlass
02-20-2005, 04:04 PM
For using a PC 7336, it is best to use a setting of 6 when using Menzerna Final Polish II or Meguiar`s No. 9 Swirl Remover, a setting of 3 or 4 when using something like Meguiar’s No. 7 Show Car Glaze and a setting of 3 for Meguiars NXT?
Also, how can you best guide how fast or slow you should moving the PC for each of these 3 types of products?
JeffM
02-20-2005, 05:35 PM
I think FP2 is ok to use on 6, but i am pretty sure Megs advises that their polishes be used on a max of 5.
#7 and any wax or sealant just need to be spread on the surface, so 3 is most likely a good speed.
SmoothAsGlass
02-20-2005, 08:11 PM
Any suggestions on the speed and pressure in which you actually move the PC?
I think FP2 is ok to use on 6, but i am pretty sure Megs advises that their polishes be used on a max of 5.
#7 and any wax or sealant just need to be spread on the surface, so 3 is most likely a good speed.
JeffM
02-20-2005, 09:33 PM
On speed 6 i only apply enough pressure to keep it steady.
You want the pad to have a good rotation, so just use "alittle" pressure.
Move the PC pretty slow, but fast enough that product isnt drying out on ya.
SmoothAsGlass
02-20-2005, 09:42 PM
Would the same movement speed of the PC apply for a setting of 3 when applying wax?
Think I have made the mistake before I putting too much pressure on the PC and moving it back and forth too quick.
On speed 6 i only apply enough pressure to keep it steady.
You want the pad to have a good rotation, so just use "alittle" pressure.
Move the PC pretty slow, but fast enough that product isnt drying out on ya.