View Full Version : After PO106FF..Glaze?
nonwelder
12-28-2005, 05:50 PM
I have heard after these Menzerna products, there is no need for a glaze and it may actually tamper with an already great look. Should I use something such as PwC. RMG, or VM? Any thoughts are appreciated!!
Brett
imported_flatstick
12-28-2005, 05:55 PM
I have heard after these Menzerna products, there is no need for a glaze and it may actually tamper with an already great look. Should I use something such as PwC. RMG, or VM? Any thoughts are appreciated!!
Brett
To be perfectly honest with you I would not. the finish is so nice :drool: that I would go straight to your LSP. these are my thoughts. I am sure other people will give you their views on it.
SpoiledMan
12-28-2005, 06:25 PM
I said it before and I`ll say it again. It`s a SIN to glaze after 85RD or 106FF!!
nonwelder
12-28-2005, 07:07 PM
Thanks! :)
imported_Neothin
12-28-2005, 07:48 PM
eh, I like glazing after using the menzerna polishes. My sig process is after a full PO85RD polishing.
X-Trail
12-28-2005, 08:24 PM
I would go straight to lsp. 106FF leaves such a wet finish.
Mad iX
12-28-2005, 08:35 PM
Don`t have PO106FF, but whenever I use PO85RD, it`s straight to LSP.
VM might make it a little wetter but I prefer the clarity.
i did a garage keep bike with 85Rd and FK 425 just trying to do the least possible because it was looking so good.
Used RMG over 85RD once and thought it took away from the finish. Cant wait to try the new 106FF with their wax over it.