Originally Posted by
Migue
I can`t comment on MF Pads since I use my HD Speed on Foam Pads, and it`s never gotten hot, even when working it at speed 6 on a flex3401 for 2 passes and heavy pressure,then down to speed 4-5 with moderate pressure for 2 passes and finishing on speed 3-4 with light to no pressure....zero heating up, the surface of the paint/panel was hot but not my pad.
Used it the other day to clean a water spot covered hood on a black CRV, cleaned up beautifully , even better than using M205 alone. This was working it outdoors,no direct sunlight (around 6pm light sun) but temperature outside was in the high 80s/low 90s and humid. Also previously worked inside of a closed garage while it was the same temperature outside, worked the entire vehicle and left product to haze on surface the whole time as i worked around the vehicle,then wiped all of it off in the end without any issues whatsoever, i was VERY impressed. See if it works better for you on a foam pad (?)
*Edit* : Paul, i submitted my post the same time as yours, so my statement regarding hot pads is not meant/typed to contradict yours, the OP is mentioning MF pads and i`m just sharing my experience with Foam instead. Just clearing that up to avoid any confusion. I did switch my pads after every panel or so.
Bookmarks