Nitro Seal part A question

**Alfisti** · 03-07-2014, 09:11 AM

After using the Nitro Seal kit you always have some part A left over.

I was wondering if it can be used as a base for other LSP. What`s the potential issues if you do this?

**Alfisti** · 03-08-2014, 11:22 AM

Anyone from HD??

**David Fermani** · 03-09-2014, 11:13 AM

Good question Paul. I`ve never tried it. I`d be more tempted to try it with another HD/3D sealant then anything else due to the base components. Might work sort of like a booster, but not sure. You mind trying it on a panel and see what happens?`

**Ben@3D** · 03-10-2014, 03:26 PM

Part A followed by HD Poxy is a nice combo. Definitely adds to the overall look and protection.

`

Have not tried it with other sealants though.

**David Fermani** · 03-10-2014, 08:32 PM

Thanks for sharing this insider info Ben!`

**Alfisti** · 03-11-2014, 10:39 AM

Thank you both for your input. When I try it with another brand LSP I`ll let you know how it works.

Ben, can you foresee problems with other products? For example, would it be better to try it with a hybrid wax rather than a pure sealant?

**Ben@3D** · 03-11-2014, 01:00 PM

Depending on the product, it` might have constancy or bonding issues?

`

Part A by itself does not work well. Its is only half of a sealant.` It needs to work with the chemicals in part B or Poxy for its best results. This may or may not be in the hybrid wax.

`

Normally, if someone was to layer a wax over a sealant, they would let it cure 24-48 hours before adding the wax.` It may be a better to use Part A with Poxy, let it cure, then use a hybrid wax a day or 2 later.