Nitro Removal Question

[Alfisti]

Have you tried simply washing it? The NS should be ok to wash by now.



Sometimes streaking come off after washing as the detergent removes the excess oils/stuff off the surface.

[Alfisti]

(modern paint systems will absorb up to a pint of water when the vehicle is washed, and must be allowed to evaporate before applying a polymer based sealant).

That`s fascinating! How does that work?

[Ben@3D]

Like I mentioned in my first post, I may have used too much of the A. Tonight, I tried two things. I didn one panel with the A and the B and then I tried another panel with just the B. They both did the same thing. I also tried using a qd to remove some of the hazing but you can still see it. My car is a black 911, any suggestions.

JW, PM Sent.

[jw]

I tried using a qd on this and it slightly helped but you can still see the hazing underneath. I`m really disappointed in this product. A complete waste of $60.

[David Fermani]

I tried using a qd on this and it slightly helped but you can still see the hazing underneath. I`m really disappointed in this product. A complete waste of $60.

Sorry that you`re disappointed, but unfortunately when excessive product (i.e. sealants) is applied, you *can* experience problems. That is pretty normal, especially on a black car where this can be magnified. I wanted to find out out much you applied so I could determine if the problem was user or product based. You`re typically able to treat 3-4 cars with a bottle of Nitro Seal. How much did you have left in each bottle after you did your car?



If you did apply too much, then I would rewash the car (or a section of it) and see if this clears up the issue. Add just a touch (cap full) of APC to your bucket. Once dry, try applying it again, but very lightly so you are applying a very thin film over the finish. Make sure NOT to mix up applicators. Use 1 for part A and the other for part B. Please let us know if this helps. I wouldn`t use QD either. They are made to gloss up your finish and am not surprise it isn`t correcting it. In this case you need to knock things down, not build them up like how a QD tends to do.



From the looks, Ben is also trying to rectify this for you too. 3D stands behind their products so please don`t think this is getting swept under the rug.

[Alfisti]

jw, it`s definitely NOT the product (unless you got a bad batch).



I`ve applied it multiple times to black vehicles and have never had streaking/issues.



Forget the QDs, have you tried washing?

[jw]

No I haven`t tried washing yet. I`ll probably wash in the next few days.

[David Fermani]

No I haven`t tried washing yet. I`ll probably wash in the next few days.

Please keep us posted on how if goes.

[Ben@3D]

JW, its a shame we can not talk over the phone. Can probably work this out in a 5 minutes. Please try the suggestions that David mentioned and let us know.