How to De-Scuff a Clear Bra

**evoking** · 09-04-2012, 07:16 PM

I have some scuffs in the clear bra on the nose. Any product or technique to get them out? I tried polish but didn`t work...

**Nth Degree** · 09-04-2012, 07:39 PM

I have had success using Menzerna Power Finish on a 4" orange LC pad with a rotary. Depends on how deep the scuffs are and the exact nature of the clear bra. It takes time because you have to go slow to not over-heat the plastic. Proceed with caution.

**JSFM35X** · 09-04-2012, 07:56 PM

I have used poorboys pro polish and a green über polishing pad on the gg da at speed 5. I did not have many deep scuffs just random dot of amber. It must have been pollen or something.

**RTexasF** · 09-05-2012, 08:22 AM

Treat it just as you would paint. Orange pads & Menzerna have always worked for me.

**Todd@RUPES** · 09-05-2012, 08:57 AM

I would recommend always testing an inconspicuous spot first. The material used to make clear bra`s can vary dramatically and respond quite differently to polishes. Many will respond similar to paint, however some will not.

**Rocket** · 09-05-2012, 09:23 AM

I`ve used Menzerna SIP and an orange pad. Just don`t over heat the area you`re working

**Beemerboy** · 09-05-2012, 09:25 AM

A chemical based polish like PB PP is what I use, to keep from causing any more marring.

**JSFM35X** · 09-05-2012, 09:44 AM

Originally Posted by Beemerboy

A chemical based polish like PB PP is what I use, to keep from causing any more marring.

This worked like a charm on my personal car.

**Jokeman** · 09-05-2012, 11:44 AM

A lot depends on the type of film used also. Do you know what type of film was used?

**Orinda Auto Detail** · 09-05-2012, 11:54 AM

I actually install film all the time and on Xpel film, Ventureshield(3m scotchgaurd is same as this now), You can use a medium aggressive polish and it will take off most scuffs. I usually try by hand first. Shoot me for this but Turtle wax ICE has enough solvents in it that seem to do a good job on film too(why waste my pinnacle or bfwd on plasic?)

**RaskyR1** · 09-06-2012, 04:00 PM

Originally Posted by Todd Helme

I would recommend always testing an inconspicuous spot first. The material used to make clear bra`s can vary dramatically and respond quite differently to polishes. Many will respond similar to paint, however some will not.

Agreed!

IME the 3M stuff has been easy to work with but I`ve had a Ventureshield job that was a PITA. Sonax Perfect Finish is my new go to product for PPF.

**Todd@RUPES** · 09-07-2012, 08:25 AM

Originally Posted by RaskyR1

Agreed!

IME the 3M stuff has been easy to work with but I`ve had a Ventureshield job that was a PITA. Sonax Perfect Finish is my new go to product for PPF.

I worked on an older 3M film that would haze no matter what I did. Sometimes you just try a spot and scratch your head in disbelief!