Hey everyone,
Had a client bring in his 335i originally for a one step polish but upon review of the vehicles paint there were tons and i mean tons of RIDS. The vehicle had light swirling which was easily taken care off. I resorted to Sonus Yellow and Power Finish and Sonus White with 3M Ultrafina for the swirling and for the RIDS and certain heavily swirled areas around the driver door, passenger door and bumper area with Sonus Yellow in combination with PG, followed up with SONUS white SIP, SONUS white PF, SONUS BLUE Ultrafina. For RIDS that did not come in bunches I resorted to LC Spot pads to keep the heavy polishing down to a minimum to keep the integrity of the clearcoat.
The client was great and understood the need to take the neccesary time to complete the work properly and I appreciated his patience. He car is his daily driver and has chalked up many healthy kilometres.
Anyways to the process and pictures.
Wash
2 Bucket Method
Meguiars Gold Class
1 bucket for Wheels
Wheel Brush
Tire Brush
EZ Detail Brush
Sheep Skin Mitts
Paint Correction
Sonus Yellow
Sonus White
Sonus Blue
LC 4 inch Yellow
LC 4 inch Orange
LC 4 inch White
Menzerna Power Gloss
Menzerna SIP
Menzerna PF
3M Ultrafina
3M Backing Plate
RB Backing Plate
Metal Polishing (exhaust tips)
3M Ultrafina
P21S Metal Polish
0000 Steel Wool
Equipment
2 Halogen Lights
3M Sun Gun
Fenix TK10
Air Compressor
Metabo Polisher
Metabo x 2
LSP
Zaino Z2Pro
Zaino Grand Finale
Befores
Alright so lets begin with the before pictures. The before pictures consist of quite a few sun shots. You'll notice the obvious swirls but if you take particular close attention that the RIDS are mainly deep straight lines. I would assume that this is from road debris on the highway just skipping off or nicking the paint. It was my fault that I did not notice how deep the RIDS were. The RIDS definitely did not pass the finger nail test
.
Ok so lets move on to the correction side of things. The first picture below is the hood. I first started off with the combination of Sonus White and Ultrafina. That barely did anything and just did not make a significant different. I bumped it up to Sonus White and PF and it got rid of the light swirling easily however the RIDS were a different matter. I made 3 passes and it barely made a dent on the test panel. I resorted to Sonus Yellow and PF, it shaved a little off the RIDS but not enough so I finally settled on PG and yellow then followed it up with White SIP, White PF then Blue Ultrafina. The result is what you see below.
50/50 of driver side door.
Driver side door completely cleared up.
50/50 Trunk
50/50 Trunk
Trunk Cleared up
The rear lights has a bit of swirling and that was looked after with the LC orange spot pad with PF and followed up with LC white spot pad 3M ultrafina.
Cleared up
License Plate Area cleared left side. Spot pads were used for this. The bumper was also propped up with my polishing bottles to provide easier access.
Other side of plate Area cleared up
Nasty bumper scratches. I didn't like this part so much but what is a detailer to do
Spot pads were used to address the bumper. The trunk was opened to polish and the plastic on the trunk was taped up to protect it.
Cleared up
Linear Mode
