Welcome to the Autopia.org. You are viewing as a guest. By joining our FREE community you will be able to interact with others. Plus, when you join you will receive instant coupon codes for special discounts with our sponsors. Registration is fast, simple and absolutely free so please, join our community today!
I bought Justin's (jsatek) 3401 and had a go at my mom's CRV this weekend. I really liked the machine and it did clean up defects faster than the PC.
The Flex did want to pull me around a bit. Most of the time it was under control but there were a few instances where it felt like it wanted to run back into its box.
I was trying to figure out which direction it pulled the worst but didn't quite get it. It also felt harder to do up and down motion rather than side to side. For example on a side panel going front to back was much easier than top to bottom. This was weird because with the PC I was used to going side to side then up and down numerous times to break up the polish. As with everything though I'm sure more experience will help.
It just has a slight learning curve and youll get the hang of it very soon.Nice to see another g35 owner too.
__________________
2003 g-35 with greddy twin turbo,s,clubflex
Club Flex
Linear Mode
