Well I finally rcvd my used Metro Air Blaster today. It works great but was a little scuffed and dirty.
I took it apart and cleaned the inside and out including the outer seal. Yes, I detailed my detailing tool. I guess I am in the right place
I wanted to use my new Black Again before I apply it to my car's back plastic valance and fender wells. So the dryer, handle and cord got a nice coat of Black Again (polymer).
My question is this- the instructions state to cure in UV/sun after applying. I don't know how to do that if I use it on the wheel wells. The car is light, but not that light.
Is this curing important?
The Metro air looks 10x better and I am hoping it works this well on the car.
Maybe I will start to use it on the tons of black trim on the Xterra.
Linear Mode
