Quote:
|
Originally Posted by Jakerooni I can help you out a bit on the confusion. Get a rotary. It'll be the most usefull tool in your arsenal. There's really is no big mystery in using a rotary. I see a thousand post on here about people actually afraid to use one. It's not some sort of bomb. It's a tool. And it's very easy to use. Start out on a low speed and flat surface. The key to using a rotary is being able to feather the trigger around tight spots. and just really know your products. If you know your products the risk of burning or messing up paint is extreamly minimal. I would honestly say the only people that burn paint using a rotary either are doing it intentionally or just don't know the products they are using. You will have to pay more attention using a rotary. I tend to keep a slight edge up when using it. The more you use one the more familiar you're going to get with what it's going to do. But don't be afraid of using one. It's not hard and makes detailing alot easier. |
Thanks for the advice, actually can I ask a few direct questions? How similar/dissimilar is the usage of a rotary to PC/UDM?
I know Makita is one of the many recommended makes, is there a good OTC (Home Depot/Rona) that is available with accessories (pads, backing plate, etc.) ?
Finally, this is the stupidest question I think I'm asking:
Are the products used the same? I mean can I still use my SSR line and maybe optimum with the rotary for swirl and scratch removal? Are the pads the same or different?
I use the PC and it does take quite a while for swirl correction, but it gets the job done. (eventunally). I've got a lot of accessories for the PC as well as PC appliable polishes, glazes, and waxes. How much is interchangable between the two? From all the reading I've done it looks as if the first parts of my detailing, the hardest parts, like swirl removal will probably be better off done with the rotary.
Wax and sealants are best applied the PC.
Anyways, thanks again for taking the time to answer.