|
~One mans opinion / observations~
This is what I do (although I have the luxury of plenty of sun heat to dry it)
·Use a soft Horse Hair brush and a vacuum to remove any loose dust or dirt
·Gently rinse cover with clean water
·Wash with a 5:1 clean water / Woolite solution, using a soft brush to loosen any stubborn dirt
·(Do not scrub surface (see Spots and Stains)
·Thoroughly rinse with clean water to remove soap solution
·Allow air-drying
·Apply 303TM High Tech Fabric Guard by spraying from approximately 6-inch above the surface with a side-to-side motion, dampen but do not saturate.
·Two applications will ensure complete coverage, allow air-drying between applications.
Place the car cover inside out on the car…repeat above (omit Tech Guard)
~Hope this helps~
Knowledge unshared is experience wasted
justadumbarchitect / so I question everything/ Jon
|