Quote:
Originally Posted by critical_level2
.............I know first I will need the backing plate. I was thinking of going with 1 orange, 1 white, 1 grey and 1 blue LC CSS 6-inch Pads. ...........The paint is pretty good and doesn't have deep scratches or need tons of correction. ............
|
OK this is what I'd recommend. Buy a 3.5" BP:
3.5" Dual Action Flexible Backing Plate- porter cable 7424 or 7336 hook and loop backing plate 3.5 inch.
3.5^^ Hook & Loop Flexiplate
And then go with all 4" pads to keep things simple:
Spot Buffing 4 inch pads - 30% thicker than the Low Profile Spot Buffs!
4^^ Erasure Turbo Pads
The 4" pads will correct much better on a PC and even for applying a glaze, wax, or sealer it doesn't take that much longer. These are the pads I would get: at least 2 (4 would be better) each of the orange and white pads. Also buy a gray, blue and/or red pad for applying a glaze, sealer, or a wax. If you're going to be using an AIO then a couple of the green pads might not be a bad idea either.
At this point in time I wouldn't be too concerned about a
PFW pad (and corresponding BP) yet unless you discover some defects you can't remove with the orange.