Quote:
Originally Posted by David Fermani
Thanks for the info Bryan. I usually use about 1/2 that much in each section I work. On a door for example, I'll lay down about 4 lines and break that panel into 1/4's. A hood will make for about 6-8 sections. If you watch the 3M video, their tech guy puts down a little more than I did. They also mention: "You may notice an oily splatter on the surrounding areas of the car as you polish. This tells you that you are using the right amount of product to get the job done right".
Aren't you getting ANY oilly splatter when you use UF?
|
David, If I remember right from the video they also mention that you should always have a "film" of polish on the surface the entire time you are using it. At times I still get some splatter, but since I have reduced the amount I am using, it is very minimal and I still have the "film" of UF on the surface.