Thanks for the initial inputs.
I'm going to test the
UDM gain next weekend and see if it's defective. But I did remember that it would only orbit the pad but not spin it if I put any pressure on it. In order for the pad to spin I actually have to lift the udm a little so there's almost no weight on it. I'm going to retest to make sure that's what it's doing then I know it may be defective.
Twista616, no offense taken and thanks for the advice. I think I'll be ok just need to practice more. I'm thinking I may be using too much polish since it's dusting and after 10 mins I still need water to clean up so the panel would wipe clean. If the polish is dried I should just be able to wipe it off with a dry MF. I'm only working in a 2x2 section. Maybe I'm going too slow as it takes me about a min to do 1 pass, then I just keep going until I see dusting. The polish looked pretty clear after 10 mins but still can't wipe off with dry MF. I must be doing something wrong, but will keep trying.
any other thoughts are welcomed. thanks again.